Welcome to coolgeography.co.uk
Back to main A level Cold environments

Processes in Cold Environments

Processes of glacier erosion, transportation, deposition and weathering.

Glacial environment next to Mount Cook, New Zealand's South Island.  Note the dead ice, the amount of debris and water that there is.

The formation of ice.

Ice forms from the compression of falling snow.  As layer upon layer of snow is added it can exert a pressure on the snow at the base, compressing that snow and forcing air out of it.  This will slowly form a more dense substance called Névé and eventually ice.  Melting and refreezing of previously fallen snow can also assist in this process.

 Weathering processes 

Glaciers are found in cold environments so the dominant form of weathering is MECHANICAL OR PHYSICAL, since biological organisms are scarce and the temperature is too low for chemical reactions to have any significant effect.  Thus, physical forces such as the wind, freeze thaw and frost shatter can have an impact.

Freeze thaw is the weathering of rock which occurs when the water, which has penetrated the joints and cracks, freezes. This process is, therefore, probably effective only in well-jointed rocks. Water expands by 9% when it freezes, and it has been suggested that this expansion causes the rock to shatter. Freeze-thaw is most active where there are a maximum number of temperature oscillations around 0 °C; it is therefore more frequent in periglacial, rather than polar environments. This can break down rock which can then be transported by the glacier.

Wind – Where sediments are exposed they can be blown by harsh winds, creating Loess deposits where this materials is laid down.

Frost disintegration  is the shattering of rock caused by the freezing of water in surface cracks and hollows, and in the pore spaces.  This is another term for Freeze thaw.

Transportation;

The sediment form weathering and erosion is moved in 3 basic ways;

Supraglacially – carried on the surface of the ice either at the sides of the ice (from valley sides) or as a medial moraine.

Englacial – debris that is found in the main body of the glacier that has been covered from subsequent snow fall.

Subglacial debris is that which is moved along under the ice by subglacial melt water channels.

Erosion Processes

Plucking

First, ice has the property of being able to freeze to rock. The glacier uses this to adhere to part of the ground. Then, as the glacier forces the ice frozen to the ground to continue moving down slope, the rock may be pulled out of the ground and moved down slope as well.

Abrasion

Second, once glaciers have rock and sediment at their bases they can push this sediment against the ground and use it like sandpaper. This abrasion of rock against rock can scour the landscape and leave large gouges, small striations, or even a finely polished surface.

Glacial Deposition

Where ever ice melts eroded and transported sediments known as moraines or tills can be deposited.  One type is ablation till, where the ice melts and dumps large amounts of unsorted materials.  Lodgement till is different, this is till that is sediment which has been deposited by plastering of glacial debris from a sliding glacier bed.  Deposition is also encouraged where ice becomes overloaded with sediment at the base, or as a glacier retreats.

   
  Think about it   
Test your knowledge of Glacial processes key terms