Welcome to coolgeography.co.uk
Back to main Back to Advanced level Back to Rivers and floods
he drainage basin hydrological cycle: the water balance.

The drainage basin
The water cycle
The changing valley shape
The water balance
Find out more

The drainage basin
This is the area of land drained by a river system (a river and its tributaries). It includes the surface run-off in the water cycle, as well as the water table. Drainage basins are separated by watersheds. A drainage basin is an example of an open system because it is open to inputs from outside, such as precipitation, and is responsible for outputs out of the system, such as output of water into the sea and evaporation of water into the atmosphere. You can see a diagram of the drainage basin below.  The drainage basin system is demarked by a watershed, this is the upper limit around the drainage basin that separates one drainage basin from another. The North East of England has 3 major drainage basins, the Tyne, Tees and Wear, and several other smaller drainage basins.  These are tiny compared to the worlds largest drainage basins, such as the Nile, Amazon and Mississippi, which covers 3,225,000km2

 

The water cycle and the Drainage Basin
This is a series of processes by which water is evaporated from the sea and eventually condenses and precipitates over the land.  It is the main input to the drainage basin and you can read detailed notes on this process at the Met Office's website.

The water cycle starts with water evaporating from the ocean, this hot moist air rises in thermals where it cools as it rises through the troposphere (at the dry adiabatic lapse rate of 9.7°C per 1000m).  As the air rises and cools it loses its capacity to hold water vapour as its relative humidity rises, and condensation occurs releasing latent heat.  This forms clouds at the dew point, and these clouds are blown inland.  Relief features can force the clouds higher, water droplets collide with one another and get bigger, and eventually the droplets are big enough to fall to earth as precipitation.  This precipitation can be stored on the surface as snow or ice, or can be intercepted by trees and vegetation.  On the trees or vegetation the water can be dripped off leaves, flow down the vegetation as stem flow or be taken up and lost as transpiration.  The combined losses of water through transpiration and evaporation are known as EVAPOTRANSPIRATION. It could also fall straight into the ground where it can percolate into the soil then infiltrate into the rock underneath if the soil and rock are permeable.  If  the rock is not permeable or the soil stores are full then surface runoff will occur.  This water will then  work its way through the soil (soil flow) or rock (through flow) or over the land and into streams and rivers.  These small tributary streams join together at confluences and the river will grow in size and strength.


The water cycle

 

Changes in valley shape

The diagram below shows the major changes downstream.

River valley changes

In the source area the drainage basin (an area of land drained by a river and its tributaries) contains V shaped valleys and waterfalls, and the dominant processes are erosion.  Erosion tends to be vertical (straight down into the land).

In the middle section of the drainage basin the river starts to erode laterally.  This section contains meanders and Ox bow lakes, and the river creates a flood plain often with Levees.  Here, Material is deposited and erosion can also occur.

In the lower drainage basin deposition dominates as a river enters a sea or lake, the valley is at its widest and deltas and estuaries are major landforms and habitats.

The water balance

When the INPUTS and OUTPUTS of the drainage basin system are balanced it is said to be in dynamic equilibrium.  However, there will be periods were there is more rainfall than others leading to more erosion, or drier periods where there will be deposition occurring.  All of this can be interpreted as a systems diagram.  This can also be shown in a water budget, which is;

Change in storage = Precipitation (P) - (Runoff (Q) + Evapotranspiration (E))

A positive balance indicates that inputs are greater than outputs and water will be stored in the system.

A negative balance indicates that outputs are greater than inputs and stores will deplete and be used up.

 

This can be shown on a soil moisture budget graph, examples for Harrogate and Malaga are shown below.  This graph comprises 3 basic sections.  Where evapotranspiration is above precipitation soil moisture utilisation will take place, that is, soil stores will be used and not replaced.  This could continue until soil moisture depletion, where there is no water left in the soil and plants will begin to die.  Once precipitation rises above evapotranspiration soil moisture recharge will occur, and soil stores will be replaced slowly.  Once the field capacity of the soil is reached (the normal amount of water a soil can hold) then we reach a situation of soil moisture surplus.

Evian Commercial
Find out more

Compare the soil moisture budget graphs for Harrogate and Malaga shown here.

Try to locate the watershed between the North Tyne, South Tyne, Tees and Wear drainage basins on the Google map below.  You may need to zoom out a little, you could add shapes to outline the watershed.

Watch the Evian commercial below and list all of the water cycle features you can identify

Look at a case study for York


View Drainage basin delineation exercise in a larger map