![]() |
||
| Back to Main Page | Back to GCSE Page | Back to Rivers, Coasts and Glaciers |
Glacial Landforms:
Corries/cirques/cwm
Aretes and pyramidal peaks
U shaped valleys and truncated spurs
Ribbon lakes
Hanging valleys
Moraine
Tasks
![]() |
Corries form in hollows where snow can accumulate. In the Northern hemisphere this tends to be on North facing slops which because of their aspect are slightly protected from the sun, which allows snow to lie on the ground for longer and accumulate. The snow compacts into ice and this accumulates over many years to com pact and grow into a corrie/cirque glacier. This moves down hill because of gravity, the mass of the ice, water at it's base and the slope it is on. The ice freezes to the back wall and as it does plucks rock out steepening the back wall. Freeze Thaw and frost shatter above the hollow on exposed rocks shatters the rock and deliver shattered rock known as scree to the ice (both on top of the ice, within it and under it). This material from plucking and frost shatter is then moved along under the ice abrading the hollow by scratching the surface rock. This creates a steep back wall and a hollow known as a corrie or cirque. At the front edge of the corrie the ice thins out at is speeds up on its journey down valley, and this area is eroded less and crevasses form. This leaves a lip of rock. When the ice melts a corrie lake can form. View an animation of this process. In France and Switzerland Corries (the
Scottish word) are known as Cirques (because of their near CIRcular
shape), Coombe in England and in Wales it is Cwm. |
Where 2 corries occur back to back, they can erode backwards through the processes outlined above. As these corries erode backwards they steepen the back walls in both corries, which eventually leaves a steep knife edged ridge called an Aręte. Where 3 or more corries erode backwards towards one another, this can create a Pyramidal peak, a steep sided pointed mountain like the Matterhorn.
|
As corrie glaciers leave
their source regions and descend down old river valleys they can make
huge changes to the landscape. One of the major change they make is to
the V-shaped valleys characteristic of the
upper reaches of
river valleys. The glaciers basically alter this V
shape into a U, by creating a
steep sided, wide valley in the shape of the letter U. They are formed by a valley glacier that moves down the valley because of
gravity.
As the glacier moves down the valley it plucks the rock from beneath and those
rocks then rub against the bed of the valley, eroding it further.
This deepens and widens the valley. |
![]() Back to the top |
Within U shaped valleys you can often find Ribbon lakes (at the bottom of the picture above). These are long and thin lakes that collect from melt water and rain water after the glacier has melted. During glaciations the glacier erodes some parts of the valley floor more than others. This could be because of varying strengths of the bedrock or because there is thicker ice in one region of the glacier than another or because there is more moraine abrading the ground in one region than another. When the glacier melts water fills the depressions (holes) where the valley floor was eroded most. These lakes can also form because melt water from receding glaciers is trapped behind Moraine, which is discussed below.
Within glacial valleys there are main glaciers and
smaller tributary glaciers (just like with rivers). The main glacier can
erode its valley to a much greater extent because they are wider, deeper, have
more mass and more moraine to use as erosive tools. The tributary valley
glaciers are smaller, have less mass and moraine hence erode their valley less.
This means that the main valley is deeper, wider and steeper, and this becomes
really evident post glaciation, when the tributary glacier is left hanging high
above the main valley. When rivers return, they often form waterfalls in
these hanging valleys. This can all be seen in the images below. You can also
see a
fantastic animation of how hanging valleys are created here.
Stage 1 in Hanging valley formation
![]() |
Stage 2 in hanging valley formation![]() |
![]() |
![]() |
|
This is the material
produced by glacial erosion. The material tends to be unsorted (it
contains really huge boulders and at the same time a fine powder called
glacial flour). It also tends to be very angular, as the processes
that form the material involve freezing and shattering.
There are different types of moraine including: |
![]() Back to the top |
Tasks
1) Have a go at a Hot Potatoes Match up exercise
2) Put together an page of images to show the range of glacial landforms using the UWSP web site
3) Have a go at this Ordnance survey map exercise
4) Glaciers penalty shoot out from juicy geography
5) Label the Franz Joseph Glacier
6) Try these cloze exercises - Corries hard version, Corries easier version, U shaped Valleys hard and U shaped Valleys easier